Home › Vehicle Interior › SEAT BELT › CHILD RESTRAINT SEAT ANCHOR BRACKET

CHILD RESTRAINT SEAT ANCHOR BRACKET > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT ASSEMBLY (for Separate Type Seatback)
(Click here)


2. REMOVE REAR SEAT ASSEMBLY (for Bench Type Seatback)
(Click here)


3. REMOVE REAR DOOR SCUFF PLATE LH


    B300785
  1. Disengage the 5 claws and guide and remove the rear door scuff plate LH.



4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Remove the front door opening trim weatherstrip LH.



5. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure as for the LH side.



7. REMOVE DECK BOARD ASSEMBLY
  1. Remove the deck board assembly.



8. REMOVE DECK FLOOR BOX LH
  1. Remove the deck floor box LH.



9. REMOVE DECK FLOOR BOX RH

HINT:
Use the same procedure as for the LH side.



10. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
  1. Remove the package tray trim panel assembly.



11. REMOVE REAR DECK TRIM COVER


    B297727
  1. Remove the 2 clips.

  1. Disengage the 4 claws and 2 guides, and remove the rear deck trim cover.



12. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
  1. Remove the bolt.



    B307773
  1. Disengage the 2 claws and disconnect the floor anchor of the rear seat 3 point type outer belt assembly.



13. REMOVE REAR ABSORBER CAP LH


    B300796
  1. Disengage the 2 claws and 2 guides, and remove the rear absorber cap LH.



14. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY


    E286958E03
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
    Text in Illustration 
    *a
    Protective Tape



    E286959
  1. Remove the No. 1 luggage compartment light assembly as shown in the illustration.

  1. Disconnect the connector and remove the No. 1 luggage compartment light assembly.



15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


  1. Turn the rear seatback hinge in the direction indicated by the arrow shown in the illustration.


    B300799E01


    Text in Illustration 
    *1
    Rear Seatback Hinge
    -
    -

  1. Remove the bolt and 2 screws.

  1. Disengage the 4 claws, 4 clips and guide, and remove the deck trim side panel assembly LH.



16. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



17. REMOVE REAR ABSORBER CAP RH

HINT:
Use the same procedure as for the LH side.



18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



19. REMOVE CROSS ANCHOR BRACKET SUB-ASSEMBLY (for Separate Type Seatback)


  1. Remove the 3 bolts and cross anchor bracket sub-assembly.


    B297198



20. REMOVE CROSS ANCHOR BRACKET SUB-ASSEMBLY (for Bench Type Seatback)


  1. Remove the 3 bolts and cross anchor bracket sub-assembly.


    B297200