Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Halogen Headlight)

HEADLIGHT ASSEMBLY (for Halogen Headlight) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect each connector.

  1. Engage the 2 clamps.

  1. Install the headlight assembly with the 2 screws and bolt.

    Torque:
    Bolt:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


3. ADJUST HEADLIGHT AIMING
(Click here)