Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE HEADLIGHT CLEANER WASHER NOZZLE COVER


    E237629
  1. Extend the headlight cleaner washer nozzle.

  1. Disengage the 2 claws and remove the headlight cleaner washer nozzle cover.

    HINT:
    Use the same procedure for the RH side and LH side.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


    E237621E01
  1. Push the tabs shown by arrows (a) and (b) and disconnect the headlight cleaner hose.



    E237622
  1. Remove the headlight cleaner clamp as shown in the illustration.



    E237624E01
  1. Pull down the headlight cleaner actuator clamp as shown in the illustration.
    Text in Illustration 
    *1
    Headlight Cleaner Actuator Clamp



  1. While pushing the tab shown by arrow (a), disengage the claw and guide to remove the headlight washer actuator sub-assembly LH as shown in the illustration.


    E237626E01



4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.