DOOR CONTROL TRANSMITTER > INSPECTION |
| 1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY |
Inspect the operation of the electrical key transmitter sub-assembly.
Remove the transmitter battery from the electrical key transmitter sub-assembly (Click here).
![]() |
Install a new or known good transmitter battery (Click here).
From outside the vehicle, approximately 1 m (3.28 ft.) away from the driver door outside door handle, test the electrical key transmitter sub-assembly by pointing its key plate at the vehicle and pressing a electrical key transmitter sub-assembly switch.
Inspect the transmitter battery capacity.
Remove the transmitter battery (Click here) from the electrical key transmitter sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery (Click here).
![]() |
| Tester Connection | Condition | Specified Condition |
| Transmitter battery positive (+) - Transmitter battery negative (-) | Power switch off, all doors closed and lock sensor touched | 2.2 to 3.2 V |