WATER PUMP WITH MOTOR > INSTALLATION |
| 1. INSTALL HV WATER PUMP BRACKET SUB-ASSEMBLY |
Install the HV water pump bracket sub-assembly with the 2 bolts.
Connect the clamp.
| 2. INSTALL INVERTER WATER PUMP ASSEMBLY |
Install the inverter water pump assembly with the 3 bolts.
Connect the connector.
![]() |
Connect the 2 water hoses.
| *1 | Clamp A |
| *2 | Clamp B |
| *a | Alignment mark (White) |
| *b | Alignment Mark (Yellow) |
| *c | Rib |
| *d | 90° |
| *e | 45° |
| 3. INSTALL INVERTER BRACKET ASSEMBLY |
Temporarily install the inverter bracket assembly with the 4 bolts.
![]() |
Tighten the 4 bolts in the sequence shown in the illustration.
Connect the earth wire with the bolt.
Install the inverter reservoir tank assembly with the 2 bolts.
![]() |
Connect the 2 wire harness clamps.
![]() |
Connect the motor cable protector with the bolt.
| 4. INSTALL INVERTER WITH CONVERTER ASSEMBLY |