Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR

WATER PUMP WITH MOTOR > REMOVAL

for Preparation Click here



1. REMOVE INVERTER WITH CONVERTER ASSEMBLY
(Click here).


2. REMOVE INVERTER BRACKET ASSEMBLY

CAUTION:
Wear insulated gloves.



    A268005
  1. Remove the bolt and separate the motor cable protector.



    A268006
  1. Disconnect the 2 wire harness clamps.



    A268007
  1. Remove the 2 bolts and separate the inverter reservoir tank assembly.



    A268008
  1. Remove the bolt and disconnect the earth wire.



    A268009
  1. Remove the 4 bolts and inverter bracket assembly.



3. REMOVE INVERTER WATER PUMP ASSEMBLY


    A266739
  1. Disconnect the 2 water hoses.

    NOTICE:
    Put pieces of cloth into the pipes and in the disconnected hoses to prevent foreign matter from entering the inverter water pump and cooling system.



    A266741
  1. Disconnect the connector.

    NOTICE:
    Apply insulating tape to the connectors of the wire harness and inverter water pump assembly with motor to prevent the entry of coolant.

  1. Remove the 3 bolts and the inverter water pump assembly.



4. REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY


    A266742
  1. Disconnect the clamp.

  1. Remove the 2 bolts and the HV water pump bracket sub-assembly.