Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (w/ Non-removable Headrest)

FRONT SEAT ASSEMBLY (w/ Non-removable Headrest) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect each connector and clamp under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B301347E01
  1. Using a E10 "TORX" socket wrench, tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B299147E01
  1. Using a E10 "TORX" socket wrench, tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



2. INSPECT SEAT SLIDE ADJUSTER LOCKS
  1. During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.



3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Engage the 3 claws to install the rear outer seat track bracket cover.



4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. INSTALL FRONT FLOOR COVER RH (for Bench Type Seatback)
  1. Engage the 3 guides.



    B301488E01
  1. Engage the clip <B> to install the front floor cover RH.

  1. Install the 2 clips <A>.



6. INSPECT SRS WARNING LIGHT
(Click here)