Home › Engine / Hybrid System › 1NZ-FXE STARTING › POWER SWITCH

POWER SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH (for LHD)


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for LHD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE CLUSTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for LHD)


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

    NOTICE:
    Do not use a moulding remover to an area other than that shown in the illustration. Using a moulding remover in an area other than that shown in the illustration may result in deformation or damage to related parts.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



5. REMOVE POWER SWITCH (for LHD)


    A267423
  1. Disengage the 2 claws and remove the power switch.

  1. Disconnect the power switch connector.



6. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY (for RHD)
(Click here).


7. REMOVE POWER SWITCH (for RHD)


    A267424
  1. Disengage the 2 claws and remove the power switch.

  1. Disconnect the power switch connector.