Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Rear Side)

WASHER NOZZLE (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WASHER NOZZLE
  1. Engage the 2 claws to install the rear washer nozzle.

  1. Connect the washer hose.



2. INSPECT REAR WASHER NOZZLE


  1. Operate the rear washer nozzle and check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E246656E01


    Text in Illustration 
    *a
    Measurement
    -
    -

    Standard Clearance:

    Area
    Measurement
    Area
    Measurement
    A
    138.4 mm (5.45 in.)
    B
    130.7 mm (5.15 in.)
    C
    60.3 mm (2.37 in.)
    D
    191 mm (7.52 in.)



3. ADJUST REAR WASHER NOZZLE


    E237619
  1. Using a screwdriver, adjust the direction of the rear washer nozzle.

    NOTICE:
    Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

    HINT:
    Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.



4. INSTALL REAR SPOILER
(Click here)