Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › INPUT SHAFT OIL SEAL

INPUT SHAFT OIL SEAL > REPLACEMENT

for Preparation Click here



1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE INPUT SHAFT TYPE T OIL SEAL


    C249664E01
  1. Using a screwdriver with its tip taped, remove the input shaft type T oil seal.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    When removing the input shaft type T oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.



3. INSTALL INPUT SHAFT TYPE T OIL SEAL


    C249665E01
  1. Coat the lip of a new input shaft type T oil seal with MP grease.

  1. Using SST and a hammer, tap in the input shaft type T oil seal.

    SST
    09330-50010  

    Oil seal installation depth:
    1.0 to 1.8 mm (0.0394 to 0.0709 in.)

    NOTICE:
    1. Ensure that no foreign matter adheres to the input shaft type T oil seal lip.
    2. Ensure that the input shaft type T oil seal is not at an angle.



4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)