Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door)

BLACK OUT TAPE (for Rear Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
(Click here)


2. REMOVE NO. 2 BLACK OUT TAPE
  1. Using a heat light, heat the No. 2 black out tape and vehicle body.
    Heating Temperature 
    Item
    Temperature
    No. 2 Black Out Tape and Vehicle Body
    40 to 60°C (104 to 140°F)

    NOTICE:
    Do not heat the vehicle body excessively.



    B298011
  1. Pull back on one of the ends of the No. 2 black out tape to remove it.

    HINT:
    When pulling on the stripe, pull it parallel to the body.