Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
  1. Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
  2. If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



    C248377
  1. Connect the connector to the tire pressure warning ECU and receiver.



    C248376
  1. Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.

  1. Install the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



2. INSTALL ROOF SIDE INNER GARNISH LH



3. REGISTER TRANSMITTER ID
(Click here)


4. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)


5. PERFORM INITIALIZATION
(Click here)