TIRE PRESSURE WARNING SYSTEM > TEST MODE PROCEDURE |
| TEST MODE (SIGNAL CHECK MODE) PROCEDURE |
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.
![]() |
| *a | 0.125 sec. |
| *b | ON |
| *c | OFF |
Press the tire pressure warning reset switch (DTC C2198/98).
Wait for 1.5 minutes with the vehicle stopped, or drive the vehicle at a speed of 50 km/h (31 mph) or more for 1 minute (DTCs C2181/81 to C2184/84).
Check that the tire pressure warning system test mode (signal check mode) DTCs are cleared.
| Test Mode (Signal Check Mode) DTC | Test Signal | Test Mode (Signal Check Mode) DTC Clear Condition |
| C2181/81 to C2184/84 | Transmitter Data | Data is received from the relevant transmitter which has a registered ID in the tire pressure warning ECU and receiver. |
| C2198/98 | Tire Pressure Warning Reset Switch Signal | A signal is received indicating that the tire pressure warning reset switch is pressed. |
Result
| Condition | Procedure |
| Test mode (signal check mode) DTCs are output | Repair the faulty part and enter Signal Check again |
| Test mode (signal check mode) DTCs are cleared | No problem |
End of test mode (signal check mode)
After completing the test mode (signal check mode), turn the power switch off and disconnect the GTS.
Test mode (signal check mode) DTCs
If a trouble code is displayed during the test mode (signal check mode) DTC check, check the diagnosis procedure listed for that code. For details of each code, refer to See page below.
| DTC No. | Detection Item | Trouble Area | See page |
| C2181/81 | Transmitter ID1 not received |
|
Click here
|
| C2182/82 | Transmitter ID2 not received |
|
Click here
|
| C2183/83 | Transmitter ID3 not received |
|
Click here
|
| C2184/84 | Transmitter ID4 not received |
|
Click here
|
| C2198/98 | Initialization switch error |
|
Click here
|