Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > REMOVAL

for Preparation Click here


NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal (Click here).



1. REMOVE ROOF SIDE INNER GARNISH LH
(Click here)


2. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
  1. Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
  2. If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



    C248376
  1. Remove the bolt.

  1. Disengage the 2 hooks to remove the tire pressure warning ECU and receiver.



    C248377
  1. Disconnect the connector from the tire pressure warning ECU and receiver.