POWER STEERING SYSTEM > EPS Warning Light Circuit |

| 1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the connectors from the power steering ECU assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G6-1 (IG) - Body ground | Power switch on (IG) | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A33-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 3.INSPECT COMBINATION METER ASSEMBLY |
Reconnect the power steering ECU assembly connector.
Perform the Active Test of the combination meter assembly using the intelligent tester (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||