Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1582/82    Assist Map Number Mismatch

for Preparation Click here


DESCRIPTION

When an incorrect hybrid vehicle control ECU is installed after the assist map has been written to the power steering ECU assembly, then DTC C1582/82 is stored because the data does not match the vehicle specifications.

DTC No.
DTC Detection Condition
Trouble Area
C1582/82
Assist map number mismatch
  1. CAN communication system
  2. Incorrect hybrid vehicle control ECU
  3. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.CHECK RELATED PART (HYBRID VEHICLE CONTROL ECU)
  1. Check if any of the parts listed below have been replaced with an incorrect part in the past.

    Related Part
    Hybrid vehicle control ECU

    NOTICE:
    When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
    1. Refer to the following procedures to remove the hybrid vehicle control ECU (Click here).

    HINT:
    1. DTC C1582/82 is stored when a part with an incorrect part number is installed for the related parts listed above.
    2. When DTC C1582/82 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.

Result 
Result
Result
Proceed to
Proceed to
All installed related parts have correct part number
A
Part with incorrect part number is installed
B


B
REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)