CAN COMMUNICATION SYSTEM > Certification ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Certification ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (SMART KEY ECU ASSEMBLY (CERTIFICATION ECU) BRANCH LINE) |
Disconnect the cable from the negative (-) auxiliary battery terminal.
![]() |
Disconnect the G79 smart key ECU assembly (certification ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G79-14 (CANH) - G79-15 (CANL) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Smart Key ECU Assembly (Certification ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the G77 smart key ECU assembly (certification ECU) connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G77-11 (E) - Body ground | Cable disconnected from negative (-) auxiliary battery terminal | Below 1 Ω |
| *a | Rear view of wire harness connector (to Smart Key ECU Assembly (Certification ECU)) |
Connect the cable to the negative (-) auxiliary battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G77-2 (+B) - Body ground | Power switch off | 11 to 14 V |
| G79-5 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||