VEHICLE PROXIMITY NOTIFICATION SYSTEM > Proximity Notification Sound OFF Indicator does not Illuminate or Turn Off |

| 1.READ VALUE USING GTS (Operation Cancel SW) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Operation Cancel SW | Vehicle approaching speaker switch / OFF or ON | OFF: Vehicle approaching speaker switch not pressed ON: Vehicle approaching speaker switch pressed | - |
| Result | Proceed to |
| The GTS display changes according to the operation of the vehicle approaching speaker switch | A |
| The GTS display does not change according to the operation of the vehicle approaching speaker switch | B |
|
| ||||
| A | |
| 2.INSPECT COMBINATION METER ASSEMBLY |
Disconnect the G85 vehicle approaching speaker controller connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G85-10 (IND) - Body ground | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - COMBINATION METER ASSEMBLY) |
Disconnect the G1 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G85-10 (IND) - G1-14 (IND) | Always | Below 1 Ω |
| G85-10 (IND) or G1-14 (IND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||