Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE EGR COOLER ASSEMBLY
(Click here)


2. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A267686
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.



3. REMOVE AIR FUEL RATIO SENSOR


    A267409
  1. Disconnect the air fuel ratio sensor connector and 2 clamps.



    A267410E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



4. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A267688
  1. Remove the 3 bolts and No. 1 exhaust manifold heat insulator.



5. REMOVE MANIFOLD SUPPORT BRACKET


    A267692
  1. Remove the 4 bolts and manifold support bracket.



6. REMOVE NO. 1 EGR PIPE


    A267693
  1. Remove the bolt, nut and No. 1 EGR pipe.

  1. Remove the gasket.



7. REMOVE EXHAUST MANIFOLD


    A268068
  1. Disconnect the wire harness clamp and oxygen sensor connector.



    A267694
  1. Remove the 3 bolts, 2 nuts and exhaust manifold.

  1. Remove the exhaust manifold to head gasket.



8. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A268065
  1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator.



9. REMOVE HEATED OXYGEN SENSOR


    A267866E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010