Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2287    LIN Communication Master Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when there is an open, short or ECU communication malfunction between the power management control ECU and certification ECU (smart key ECU assembly).

DTC No.
DTC Detection Condition
Trouble Area
B2287
There is an open, short or ECU communication malfunction between power management control ECU and certification ECU (smart key ECU assembly).
  1. Power management control ECU
  2. Certification ECU (smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B228566E13


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. If the certification ECU (smart key ECU assembly) or power management control ECU is replaced, refer to Service Bulletin.
  3. When using the intelligent tester to troubleshoot with the power switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.

1.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    HINT:
    Check for both "Entry&Start" and "Power Source Control" DTCs.

    Result:
    Result
    Proceed to
    Only DTC B2287 is output.
    A
    DTC B2287 and B2785 are output simultaneously.
    B

    HINT:
    When DTC B2287 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.



B
GO TO DTC B2785 (Click here)
A


2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - AUXILIARY BATTERY AND BODY GROUND)
  1. Disconnect the G57 and G58 power management control ECU connectors.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G57-6 (E1) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G57-1 (AM22) - Body ground
    Power switch off
    11 to 14 V
    G58-7 (AM21) - Body ground
    Power switch off
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER MANAGEMENT CONTROL ECU)
  1. Disconnect the G54 certification ECU (smart key ECU assembly) connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G58-11 (LIN2) - G54-12 (LIN)
    Always
    Below 1 Ω
    G58-11 (LIN2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK SMART ENTRY AND START SYSTEM (for Entry Function)
  1. Check that the entry lock and unlock function operates normally (Click here).

    OK:
    Entry lock and unlock function operates normally.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)