Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A267865E01
  1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm (1.18 in.)
    *b
    Fulcrum Length
    260 mm (10.2 in.)

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 260 mm (10.2 in.) (Click here).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.



2. INSTALL EXHAUST MANIFOLD
(Click here).