FRONT DOOR BELT MOULDING > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER |
| 5. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws and front No. 2 speaker assembly.
| 6. REMOVE FRONT DOOR SERVICE HOLE COVER |
![]() |
Remove the front door service hole cover.
| 7. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the front door No. 2 service hole cover.
Connect the cable to the negative (-) auxiliary battery terminal and power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the negative (-) auxiliary battery terminal and power window regulator master switch assembly.
![]() |
Remove the 2 bolts.
![]() |
Remove the front door glass sub-assembly as shown in the illustration.
| 8. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |
![]() |
Apply protective tape to the door panel in the area around the front door glass outer weatherstrip assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 5 claws.
| *1 | Protective Tape |
Disengage the guide and remove the front door glass outer weatherstrip assembly.