Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.

System Name
See Procedure
Power Door Lock Control System
Click here


2.PRECAUTIONS WHEN USING INTELLIGENT TESTER
  1. When using the intelligent tester with the power switch off to troubleshoot:
    Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5-second intervals until communication between the intelligent tester and the vehicle begins.

  2. After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the power switch is turned on (IG).


3.DOOR CONTROL RECEIVER EXPRESSION
The type of door control receiver used on this model differs depending on the specifications of the vehicles. The expressions listed in the table below are used in this section.

Vehicle Specification
Part Name in Manual
Actual Part Name
for 12 Pin Type
Door control receiver
Door control and tire pressure monitoring system receiver assembly
for 5 Pin Type
Door control receiver
Door control receiver assembly