DTC C2179/79 Tire Pressure Monitor ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| C2179/79 | Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the M48 tire pressure warning ECU and receiver connector.
Disconnect the G59 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M48-5 (PRG) - G59-4 (PRG) | Always | Below 1 Ω |
| M48-5 (PRG) or G59-4 (PRG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER |
Replace the tire pressure warning ECU and receiver (Click here).
| NEXT | |
| 3.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Turn the power switch off.
Turn the power switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||