Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver seat (Click here).



2. REMOVE FRONT SEAT INNER CUSHION SHIELD


    B307479
  1. Disengage the 2 claws and 5 guides to remove the front seat inner cushion shield.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY
  1. Disengage each clamp under the front seat assembly.



    B309594
  1. Disengage the clamp.

  1. Remove the nut and front seat inner belt assembly.



4. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver seat .



5. REMOVE FRONT SEAT CUSHION SHIELD

HINT:
Use the same procedure as for the driver seat



6. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

HINT:
Use the same procedure as for the driver seat .



7. SEPARATE FRONT SEAT AIRBAG ASSEMBLY

HINT:
Use the same procedure as for the driver seat .



8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure as for the driver seat .



9. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    B294117
  1. Remove the 2 hog rings.



    B296371
  1. Remove the 18 hog rings and the separate type front seat cushion cover from the occupant detection sensor (separate type front seat cushion pad).