DTC U0129 Lost Communication with Brake System Control Module |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0129 | No communication from the brake booster with master cylinder assembly (skid control ECU) continues. |
|

| 1.RECONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
|
| ||||
| OK | |
| 2.RECONFIRM DTC OUTPUT |
Check if Hybrid Control of the power management control ECU outputs only DTC U0129.
| Result | Proceed to |
| The power management control ECU outputs only DTC U0129. (Intelligent tester display: Hybrid Control) | A |
| The power management control ECU outputs DTC U0100 and U0129. (Intelligent tester display: Hybrid Control) | B |
|
| ||||
| A | |
| 3.CHECK FOR OPEN IN CAN BUS LINES (BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY BRANCH LINE) |
![]() |
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the brake booster with master cylinder assembly (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A41-35 (CA2H) - A41-34 (CA2L) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Brake Booster with Master Cylinder Assembly (Skid Control ECU)) |
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||