DTC B2275 STSW Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2275 | Certification ECU (smart key ECU assembly) internal HV activation request output circuit malfunction (1-trip detection logic*) |
| Turn the power switch on (IG) and wait 10 seconds or more, then start the hybrid control system 3 times. |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
| - |

| DTC | Data List Item | Active Test Item |
| B2275 | Power Source Control
| - |
| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Turn the power switch on (IG).
After 25 seconds have elapsed, check if the DTC has been set again.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the G77 connector from the certification ECU (smart key ECU assembly).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G77-2 (+B) - Body ground | Power switch off | 11 to 14 V |
| *a | Rear view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G77-11 (E) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - HYBRID VEHICLE CONTROL ECU) |
Disconnect the G85 the certification ECU (smart key ECU assembly) connector.
Disconnect the G58 hybrid vehicle control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G58-9 (ST2) - G58-7 (ST2) | Always | Below 1 Ω |
| G58-9 (ST2) or G58-7 (ST2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the G85 certification ECU (smart key ECU assembly) connector.
Reconnect the G58 hybrid vehicle control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G77-7 (ST2) - G85 - 11 (E) | Brake pedal depressed, power switch pressed for approx. 3 sec. → power switch released | 9 V Higher→ Below 1 V |
|
| ||||
| OK | ||
| ||