Home › Vehicle Exterior › LIGHTING (EXT) › FRONT TURN SIGNAL LIGHT ASSEMBLY

FRONT TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY


    E237707
  1. Remove the bolt.

  1. Disengage the 2 claws and remove the front turn signal light assembly.



3. REMOVE FRONT TURN SIGNAL LIGHT BULB


    E237708
  1. Turn the front turn signal light plug assembly with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the front turn signal light bulb from the front turn signal light plug assembly.