Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY
(Click here)


2. REMOVE COOLER EXPANSION VALVE


    E238228
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



3. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


  1. for Type A:



      E238229
    1. Remove the 4 screws.



  1. for Type B:



      E288000
    1. Remove the 6 screws.



    E238230
  1. Disengage the clamp and disconnect the connector from the lower heater case.

  1. Disengage the 4 claws and remove the lower heater case.



    E235037
  1. Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor from the upper heater case.



    E235039
  1. Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.



4. REMOVE FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    E234954
  1. Remove the front evaporator temperature sensor (No. 1 cooler thermistor).