DTC C2198/98 Initialization Switch (for Test Mode DTC) |
| DTC No. | DTC Detection Condition | Trouble Area |
| C2198/98 | Test mode procedure is performed. |
|

| 1.INSPECT TIRE PRESSURE WARNING RESET SWITCH |
![]() |
Remove the tire pressure warning reset switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (INT) - 2 (E) | On | Below 1 Ω |
| Off | 10 kΩ or higher |
| *a | Component without harness connected (Tire Pressure Warning Reset Switch) |
| *b | On |
| *c | Off |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER) |
Disconnect the G82 tire pressure warning reset switch connector.
Disconnect the M48 tire pressure warning ECU and receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M48-3 (CLSW) - G82-1 (INT) | Always | Below 1 Ω |
| M48-3 (CLSW) or G82-1 (INT) - Body ground | Always | 10 kΩ or higher |
| G82-2 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||