Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › INVERTER CURRENT SENSOR

INVERTER CURRENT SENSOR > DISASSEMBLY

for Preparation Click here


HINT:
For the disassembly procedure of the inverter with converter assembly, refer to the disassembly procedure of the MG control computer with bracket sub-assembly (Click here).



1. REMOVE INVERTER CURRENT SENSOR SUB-ASSEMBLY


  1. Apply protective tape to the inverter terminal with sensor sub-assembly as shown in the illustration.

    NOTICE:
    Use non-residue type tape.



    A361143E02


    Text in Illustration 
    *1
    Protective Tape
    -
    -
    *a
    Terminal Tray
    -
    -



    A361144
  1. Disengage the 2 wire harnesses of the inverter current sensor sub-assembly from each clamp as shown in the illustration.



    A361145E01
  1. Remove the 2 bolts and inverter current sensor sub-assembly.

    NOTICE:
    Do not touch the bus-bars.

    Text in Illustration 
    *a
    Terminal Tray