Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0225220 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


DTC CHECK (USING SST CHECK WIRE)


a.
C204945N01
1.792,1.344 1.792,1.865 1.792,1.865 1.979,1.865 false 1.615,0.792 1.615,0.271 1.615,0.271 1.802,0.271 false 2.021,1.781 2.271,1.969 0.25,0.188 10 false TC 1.844,0.198 2.094,0.375 0.25,0.177 10 false CG

Check for DTCs (Current DTCs).

i.

Turn the power switch on (IG), and wait for at least 60 seconds.


ii.

Using SST, connect terminals TC and CG of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.




b.

Check for DTCs (History DTCs).

i.

Turn the power switch off.


ii.

Using SST, connect terminals TC and CG of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.



iii.

Turn the power switch on (IG), and wait for at least 60 seconds.



c.

Read the DTCs.

C262359E07
0.25,0.146 3.135,0.417 2.885,0.271 10 false Normal System Code (without History DTCs): 0.208,2.083 2.865,2.333 2.656,0.25 10 false Normal System Code (with History DTCs): 1.104,0.802 1.729,1.01 0.625,0.208 10 false 0.25 sec. 1.208,1.573 1.833,1.781 0.625,0.208 10 false 0.25 sec. 0.375,1.083 0.667,1.333 0.292,0.25 10 false ON 0.375,1.448 0.667,1.698 0.292,0.25 10 false OFF 0.375,2.917 0.667,3.167 0.292,0.25 10 false ON 0.375,3.333 0.667,3.583 0.292,0.25 10 false OFF 1.417,3.438 2.042,3.646 0.625,0.208 10 false 0.25 sec. 1.208,2.708 1.833,2.917 0.625,0.208 10 false 0.75 sec. 3.281,0.771 6,1.052 2.719,0.281 10 false DTC (Example Codes 11 and 31): 3.656,1.167 4.198,1.333 0.542,0.167 10 false 0.5 sec. 4.271,1.167 4.813,1.333 0.542,0.167 10 false 2.5 sec. 5.625,1.167 6.167,1.333 0.542,0.167 10 false 4.0 sec. 3.333,1.75 3.625,2 0.292,0.25 10 false ON 3.333,2.188 3.625,2.438 0.292,0.25 10 false OFF 3.875,3.167 4.49,3.417 0.615,0.25 10 false DTC 11 4.958,3.167 5.688,3.458 0.729,0.292 10 false DTC 31 6.344,2.552 7.042,2.823 0.698,0.271 10 false Repeated 3.833,2.635 4.375,2.802 0.542,0.167 10 false 1.5 sec. 4.667,2.646 5.208,2.813 0.542,0.167 10 false 0.5 sec.

i.

Read the blinking patterns of the DTCs. As an example, the blinking patterns for the normal system code and DTCs 11 and 31 are shown in the illustration.

·

Normal system code indication (without history DTCs)

The light blinks twice per second.

·

Normal system code indication (with history DTCs)

When a history DTC is stored in the airbag ECU assembly, the light blinks only once per second.

·

DTC indication

The first blink(s) indicate the first number of the DTC. The second blink(s) indicate the second number of the DTC and occur after a 1.5-second pause.


NOTICE:

When a DTC includes a letter (such as DTC 8A), the light blinks 8 times and then blinks 10 times to indicate the A after a 1.5-second pause.

Comparison Table
Number of Blinks Indicated Letter
10 A
11 B
12 C
13 D
14 E
15 F


If there is more than 1 code, there will be a 2.5-second pause between each code. After all codes are shown, there will be a 4.0-second pause, and then all codes will be repeated.

HINT:
·

If 2 or more malfunctions are detected, the indication begins with the smaller-numbered code.

·

If DTCs are indicated without connecting the terminals, refer to TC and CG Terminal Circuit.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>TC and CG Terminal Circuit






DTC CLEAR (USING SST CHECK WIRE)


a.

Clear the DTCs.

i.

When the power switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning the power switch off. In this case, proceed to the next step.



ii.

Using SST, connect terminals TC and CG of the DLC3, and then turn the power switch on (IG).

SST
09843-18040  


iii.

Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.


iv.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals TC and CG of the DLC3.


v.

The SRS warning light will go off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Disconnect terminal TC within 2 to 4 seconds after the SRS warning light goes off.


vi.

The SRS warning light will come on again within 2 to 4 seconds after disconnecting terminal TC. Reconnect terminals TC and CG within 2 to 4 seconds after the SRS warning light comes on.


vii.

Check if the SRS warning light goes off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

C262384E13
0.115,0.667 1.083,0.917 0.969,0.25 10 false Power Switch 1.656,0.875 2.073,1.125 0.417,0.25 10 false OFF 1.667,0.5 2.344,0.792 0.677,0.292 10 false On (IG) 1.667,1.188 2.083,1.438 0.417,0.25 10 false Open 1.667,1.583 2.417,1.75 0.75,0.167 10 false Connected 1.667,2.542 2.083,2.792 0.417,0.25 10 false OFF 1.667,2.167 2.083,2.417 0.417,0.25 10 false ON 0.083,2.333 1.333,2.583 1.25,0.25 10 false SRS Warning Light* 0.083,1.417 1.25,1.667 1.167,0.25 10 false DLC3 (TC and CG) 0.5,2.875 1.667,3.042 1.167,0.167 10 false T1: 0 to ∞ sec. 0.5,3.135 1.667,3.302 1.167,0.167 10 false T2: approx. 6 sec. 0.5,3.406 1.667,3.573 1.167,0.167 10 false T3: 3 to 5 sec. 0.5,3.688 1.667,3.854 1.167,0.167 10 false T4: 3 to 10 sec. 0.5,3.948 1.667,4.115 1.167,0.167 10 false T5: 2 to 4 sec. 0.5,4.229 1.667,4.396 1.167,0.167 10 false T6: 1 to 5 sec. 0.5,4.5 1.667,4.667 1.167,0.167 10 false T7: within 1 sec. 2.333,4.229 6.146,4.51 3.813,0.281 10 false *: History DTC 21 is shown in this illustration. 2.448,3.5 3.615,3.667 1.167,0.167 10 false T1 2.854,3.5 4.021,3.667 1.167,0.167 10 false T2 3.25,3.5 3.583,3.667 0.333,0.167 10 false T3 3.75,3.5 4.083,3.667 0.333,0.167 10 false T4 4.167,3.5 4.5,3.667 0.333,0.167 10 false T5 4.417,3.5 4.75,3.667 0.333,0.167 10 false T6 4.688,3.5 5.021,3.667 0.333,0.167 10 false T5 5.198,3.5 5.531,3.667 0.333,0.167 10 false T5 5.719,3.5 6.052,3.667 0.333,0.167 10 false T5 4.938,3.5 5.271,3.667 0.333,0.167 10 false T6 5.458,3.5 5.792,3.667 0.333,0.167 10 false T6 5.969,3.5 6.302,3.667 0.333,0.167 10 false T7 3.625,2.875 4.24,3.073 0.615,0.198 10 false 1.5 sec. 3.083,1.76 4.25,1.927 1.167,0.167 10 false 0.5 sec. 3.615,1.771 4.781,1.938 1.167,0.167 10 false 0.5 sec. 5.625,1.771 6.229,1.958 0.604,0.188 10 false 0.25 sec. 6.229,1.771 6.906,1.938 0.677,0.167 10 false 0.25 sec.




DTC CHECK (USING GTS)


a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG), and wait for at least 60 seconds.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.

Body Electrical > SRS Airbag > Trouble Codes
50001 188

f.

Check for DTCs by following the prompts on the GTS screen.

HINT:

Refer to the GTS operator's manual for further details.




DTC CLEAR (USING GTS)


a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG), and wait for at least 60 seconds.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.

Body Electrical > SRS Airbag > Clear DTCs
50002 188

f.

Clear the DTCs by following the prompts on the GTS screen.

HINT:

Refer to the GTS operator's manual for further details.