The airbag ECU assembly consists of the acceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the airbag ECU assembly receives signals from the acceleration sensor and pressure sensor, it determines whether the airbags and pretensioners should be deployed.
DTC B1000/31 is stored when a malfunction is detected in the airbag ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Test Mode / Check Mode |
|---|---|---|---|---|
| B1000/31 | Center Airbag Sensor Assembly Malfunction | Airbag ECU assembly malfunction | Airbag ECU assembly | Does not apply to test/check mode |
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
If only DTC B1000/31 is output, do not clear the DTC, replace the airbag ECU assembly.
If any DTCs other than DTC B1000/31 are also output, troubleshoot those DTCs first.
| Result | Proceed to |
|---|---|
| Only DTC B1000/31 is output | A |
| DTC B1000/31 and other DTCs are output | B |
A
B
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART