Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM3210E _57 Power Source / Network _047508 POWER DISTRIBUTION _0227180 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 1 integration relay removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E336551C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 3 claws to remove the No. 1 relay block cover as shown in the illustration.


Hide 82641 4.REMOVE NO. 1 INTEGRATION RELAY

a.
E336555C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws.


b.

Pull up the No. 1 integration relay as shown in the illustration.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.



c.
E336558

Disconnect the 2 connectors and remove the No. 1 integration relay.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.