Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM3210E _58 Vehicle Interior _047539 SUPPLEMENTAL RESTRAINT SYSTEMS _0230368 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 81260 2.REMOVE GLOVE BOX LIGHT ASSEMBLY

Hide 82142A 3.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B432391C01
1.01,2.792 0.865,3.115 0.865,3.115 0.698,3.115 true 0.531,3.031 0.844,3.188 0.313,0.156 10 false *a
*a Slider


w/o Passenger Airbag ON/OFF Indicator:

i.

Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




d.
B432322C01
0.677,2.99 0.927,2.677 0.927,2.677 1.135,2.677 true 1.177,2.594 1.49,2.75 0.313,0.156 10 false *a
*a Slider


w/ Passenger Airbag ON/OFF Indicator:

i.

Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




Hide 4.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:
B417757C02
0.917,0.938 1.063,1.125 0.146,0.188 10 false .
V100155

Deployment Side


When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.

w/o Passenger Airbag ON/OFF Indicator:

i.
B432393

Remove the 2 screws.


ii.
B432394C01
2.052,1.292 2.344,1.667 2.344,1.667 2.594,1.667 true 2.615,1.573 2.823,1.792 0.208,0.219 10 true *a
*a Passenger Airbag Door Retainer


Using a screwdriver, pry back the passenger airbag door retainer to disengage the 3 hooks as shown in the illustration.

NOTICE:

Do not damage the deployment surface of the instrument panel passenger airbag assembly.



iii.
B434253

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the lower instrument panel sub-assembly.



b.

w/ Passenger Airbag ON/OFF Indicator:

i.
B432324

Remove the 2 screws.


ii.
B432325C01
2.219,1.333 2.563,1.688 2.563,1.688 2.771,1.688 true 2.792,1.594 3.01,1.813 0.219,0.219 10 true *a
*a Passenger Airbag Door Retainer


Using a screwdriver, pry back the passenger airbag door retainer to disengage the 3 hooks as shown in the illustration.

NOTICE:

Do not damage the deployment surface of the instrument panel passenger airbag assembly.



iii.
B432327

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the lower instrument panel sub-assembly.



Hide 82142A 6.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.

w/o Passenger Airbag ON/OFF Indicator:

i.
B434254C01
1.688,1.958 2.604,1.958 true 0.802,0.667 0.958,0.969 0.958,0.969 1.281,0.969 true 1,1.667 1.271,1.667 1.271,1.667 1.427,1.958 true 0.802,1.573 1.021,1.771 0.219,0.198 10 true *a 2.656,1.885 2.969,2.042 0.313,0.156 10 false *b 1.313,0.885 1.625,1.042 0.313,0.156 10 false *c
*a Protective Tape
*b Airbag Connector
*c Airbag Connector Lock


Disengage the clamp.


ii.

Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.


iii.

Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.




b.

w/ Passenger Airbag ON/OFF Indicator:

i.
B432328C01
0.781,0.74 0.979,1.104 0.979,1.104 1.24,1.104 true 1.073,1.417 1.396,1.417 1.396,1.417 1.594,1.781 true 0.938,1.646 1.26,1.646 1.26,1.646 1.479,1.875 true 1.927,1.969 2.542,1.969 true 0.792,1.552 1.104,1.708 0.313,0.156 10 false *a 0.917,1.344 1.229,1.5 0.313,0.156 10 false *b 1.271,1.01 1.583,1.167 0.313,0.156 10 false *c 2.573,1.896 2.885,2.052 0.313,0.156 10 false *b
*a Protective Tape
*b Airbag Connector
*c Airbag Connector Lock


Disengage the clamp.


ii.

Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.


iii.

Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.