Be sure to correctly follow the removal and installation procedures for the rear airbag sensors.
89834
1.INSPECT REAR AIRBAG SENSOR (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
89834
2.INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
Visually check the rear airbag sensors for defects if a quarter panel of the vehicle or the area around a quarter panel is damaged.
The defects are as follows:
Cracks in the sensor housing
Dents in the sensor housing
Chips in the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found, replace the rear airbag sensor with a new one.
89834
3.INSPECT REAR AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)
When airbags have deployed as the result of a collision, be sure to replace all rear airbag sensors in the damaged areas (anywhere in need of repair).
Visually check the rear airbag sensors in undamaged areas for defects.
The defects are as follows:
Cracks in the sensor housing
Dents in the sensor housing
Chips in the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found or a rear airbag sensor has detected a major collision, replace the rear airbag sensor with a new one.