Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0230760 FRONT EVAPORATOR TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88625 1.INSTALL NO. 1 COOLER THERMISTOR

a.
E338576C03
2.406,3.948 3.063,2.719 true 2.938,3.938 3.198,2.708 true 1.396,0.563 2.125,0.948 true 2.531,0.958 2.917,0.615 true 2.292,3.958 2.604,4.115 0.313,0.156 10 false *a 2.844,3.969 3.156,4.125 0.313,0.156 10 false *b 1.219,0.417 1.531,0.573 0.313,0.156 10 false a 2.969,0.49 3.281,0.646 0.313,0.156 10 false b 0.156,2.958 0.469,3.115 0.313,0.156 10 false A 1.208,3.927 1.521,4.083 0.313,0.156 10 false B 1.958,4.229 2.271,4.385 0.313,0.156 10 false C 2.271,0.365 2.583,0.521 0.313,0.156 10 false X
*a Fixed Part
*b Sensor Part


Install the No. 1 cooler thermistor as shown in the illustration.

Installation Position:
Part Length
A 50.0 mm (1.97 in.)
B 67.9 mm (2.67 in.)
C 168.3 mm (6.63 in.)


NOTICE:
·

Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

·

When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).

·

After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.

·

Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".




Hide 88501 2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 88515 3.INSTALL COOLER EXPANSION VALVE

Hide 87107A 4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

Hide 87050D 7.INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

Hide 82210K 8.INSTALL AIR CONDITIONING HARNESS ASSEMBLY