Home › Vehicle Exterior › LIGHTING (EXT) › REAR TURN SIGNAL LIGHT BULB
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231475 REAR TURN SIGNAL LIGHT BULB A

LIGHTING (EXT)  REAR TURN SIGNAL LIGHT BULB  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81498 1.REMOVE REAR COMBINATION LIGHT COVER

Hide 2.SEPARATE REAR COMBINATION LIGHT ASSEMBLY

a.
E337048C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear combination light assembly as shown in the illustration.


b.
E337049

Remove the 2 screws.


c.
E337050C01
1.583,1.083 0.667,1.25 0.667,1.25 1.583,0.833 true 1.417,0.583 2.25,0.333 2.25,0.333 1.917,0.667 true 0.49,1.188 0.802,1.344 0.313,0.156 10 false *a 2.292,0.26 2.604,0.417 0.313,0.156 10 true *b
*a Pin
*b Guide
V113147

Remove in this Direction


Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the 2 pins and 2 guides and separate the rear combination light assembly.

NOTICE:

To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.



Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E337057C01
0,0 0,0 false
V113147

Remove in this Direction


Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.


Hide 81550L 4.INSTALL REAR TURN SIGNAL LIGHT BULB

a.

Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.


b.
E337058C01
0,0 0,0 false
V113147

Install in this Direction


Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.


Hide 5.INSTALL REAR COMBINATION LIGHT ASSEMBLY

a.
E337051C01
1.583,1.083 0.667,1.25 0.667,1.25 1.583,0.833 true 1.417,0.583 2.417,0.25 2.417,0.25 1.917,0.667 true 0.438,1.177 0.75,1.333 0.313,0.156 10 false *a 2.469,0.177 2.781,0.333 0.313,0.156 10 true *b
*a Pin
*b Guide
V113147

Install in this Direction


Engage the 2 guides and 2 pins to temporarily install the rear combination light assembly as shown in the illustration.


b.

Install the rear combination light assembly with the 2 screws.


c.

Remove the protective tape.


Hide 81498 6.INSTALL REAR COMBINATION LIGHT COVER