Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
64910J
1.REMOVE TONNEAU COVER ASSEMBLY
58415E
2.REMOVE REAR NO. 1 FLOOR BOARD
58432D
3.REMOVE DECK BOARD RETAINER
64997
4.REMOVE DECK FLOOR BOX LH (w/o Spare Tire)
64995
5.REMOVE DECK FLOOR BOX RH (w/o Spare Tire)
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64993
6.REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)
64997
7.REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64995
8.REMOVE DECK FLOOR BOX RH (w/ Compact Spare Tire)
for RH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64995
9.REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)
64997
10.REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)
for LH Side:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64718D
11.REMOVE DECK TRIM SERVICE HOLE COVER
58460D
12.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)
64716D
13.REMOVE REAR DECK TRIM COVER
67918A
14.REMOVE REAR DOOR SCUFF PLATE
62332A
15.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
71940A
16.REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
71940A
17.REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
71960B
18.REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
73350C
19.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
20.REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side)
21.REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side)
22.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
23.REMOVE REAR SEAT CUSHION LOCK HOOK
76974F
24.REMOVE REAR UNDER SIDE COVER
71304C
25.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY
62552F
26.REMOVE REAR SEAT SIDE GARNISH
58460D
27.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Side)
64937A
28.REMOVE NO. 1 TONNEAU COVER HOLDER CAP
64938
29.REMOVE TONNEAU COVER HOOK A
81330
30.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)
64740C
31.REMOVE DECK TRIM SIDE PANEL ASSEMBLY
81498
32.REMOVE REAR COMBINATION LIGHT COVER
|
Insert Moulding Remover Here |
|
Remove in this Direction |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 guides to remove the rear combination light cover as shown in the illustration.
33.REMOVE REAR COMBINATION LIGHT ASSEMBLY
Disconnect the connector.
|
Protective Tape |
Apply protective tape around the rear combination light assembly as shown in the illustration.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Remove in this Direction |
Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the 2 pins and 2 guides and separate the rear combination light assembly.
To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.
Disengage the grommet to remove the rear combination light assembly.