Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0232459 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1611  ECU Malfunction  


DESCRIPTION

This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.

HINT:

The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1611 ECU Malfunction When one of the following conditions is met:
·

EEPROM status (Initial read) malfunction

·

CPU communication malfunction

·

ASIC output malfunction


Rear television camera assembly

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Parking Assist Camera / Data List.


e.

Read the Data List according to the display on the GTS.

Chassis > Parking Assist Camera > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
EEPROM Status (Initial read) Rear television camera assembly information OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal
-
CPU Communication Status Rear television camera assembly information OK or NG OK: Rear television camera assembly normal
NG: Rear television camera assembly abnormal
-
ASIC Output Status Output condition of video signal OK or NG OK: Output condition of video signal is normal
NG: Output condition of video signal is abnormal
-
Chassis > Parking Assist Camera > Data List
Tester Display
EEPROM Status (Initial read)
CPU Communication Status
ASIC Output Status
50003 85 36,43,46
Result:
Result Proceed to
OK is displayed for all items A
NG is displayed for EEPROM status (Initial read)
NG is displayed for items other than EEPROM status (Initial read) B




A

2.PERFORM CALIBRATION

B

REPLACE REAR TELEVISION CAMERA ASSEMBLY

2.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

i.

Rear television camera assembly optical axis adjustment (back camera position setting).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION




Result:
Proceed to
NEXT



NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Chassis > Parking Assist Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Chassis > Parking Assist Camera > Trouble Codes
50001 85
HINT:
·

If DTC C1611 is output, perform the procedure to register the vehicle information into the rear television camera assembly.

·

If DTC C1611 is still output after performing the procedure to register the vehicle information into the rear television camera assembly 3 times, replace the rear television camera assembly.




Result:
Result Proceed to
DTC C1611 is output A
DTC C1611 is not output B



A

REPLACE REAR TELEVISION CAMERA ASSEMBLY

B

END