Home › Vehicle Interior › SEAT › LUMBAR SWITCH(for Manual Seat)
RM3210E _58 Vehicle Interior _047549 SEAT _0234666 LUMBAR SWITCH(for Manual Seat) A

SEAT  LUMBAR SWITCH(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lumbar power seat switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Fromt lumbar power seat switch is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE LH

Hide 72551 4.REMOVE NO. 1 RECLINING HINGE COVER

Hide 72526A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

Hide 71849 6.REMOVE SEAT ADJUSTER COVER CAP LH

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 84922A 8.REMOVE FRONT LUMBAR POWER SEAT SWITCH

a.
B432133

Remove the 2 screws and front lumbar power seat switch from the front seat cushion shield LH.