Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
72277A
1.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR (for Driver Side)
w/ Airbag Cut Off Switch:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SEAT POSITION SENSOR>REMOVAL
89178A
2.REMOVE SEAT POSITION AIRBAG SENSOR (for Driver Side)
w/ Airbag Cut Off Switch:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SEAT POSITION SENSOR>REMOVAL
89952
3.REMOVE OCCUPANT DETECTION ECU (for Front Passenger Side)
w/ Occupant Classification System:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION ECU>REMOVAL
73240
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73230
5.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
71074S
6.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Disconnect the rubber band of the separate type front seatback cover.
72495
7.REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)
| *a | Protective Tape |
|
Remove in this direction |
Operate the vertical adjusting handle and using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the vertical adjusting handle as shown in the illustration.
72551
8.REMOVE NO. 1 RECLINING HINGE COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
Disengage the guide to remove the No. 1 reclining hinge cover.
72526A
9.REMOVE RECLINING ADJUSTER RELEASE HANDLE
Remove the reclining adjuster release handle.
71849
10.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)
| *a | Protective Tape |
|
Remove in this direction (1) |
|
Remove in this direction (2) |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.
Disengage the 2 guides to remove the seat adjuster cover cap as shown in the illustration.
71812D
11.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)
Disengage the 2 claws.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 3 claws and 2 guides (A) as shown in the illustration.
Disengage the guide (B) to remove the front seat cushion shield as shown in the illustration.
w/ Lumbar Support:
Disengage the 2 clamps.
Disconnect the front lumbar power seat switch connector.
84922A
12.REMOVE FRONT LUMBAR POWER SEAT SWITCH (w/ Lumbar Support)
71862
13.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
Disengage the 2 claws.
|
Remove in this direction |
Disengage the 2 claws and 2 guides to remove the front seat inner cushion shield as shown in the illustration.
71811D
14.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)
Disengage the 2 claws.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 2 claws and 2 guides (A) as shown in the illustration.
Disengage the guide (B) to remove the front seat cushion shield as shown in the illustration.
71861
15.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
Disengage the 3 claws.
|
Remove in this direction |
Disengage the 2 claws and 2 guides to remove the front seat inner cushion shield as shown in the illustration.
72497B
16.REMOVE VERTICAL ADJUSTER BRACKET COVER (for Driver Side)
Disengage the claw to remove the vertical adjuster bracket cover.
17.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Disengage the 2 hooks.
w/ Lumbar Support:
Disconnect the connector.
Disengage the clamp.
w/ Seat Heater System:
Disconnect the connector.
Disengage the clamp.
Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.
Disengage the 4 clamps first.
Remove the 4 bolts.
Disengage the 4 guides to remove the separate type front seatback assembly from the separate type front seat cushion assembly.
71931
18.REMOVE FRONT SEAT HEADREST SUPPORT
Disengage the 3 hooks.
w/ Seat Heater System:
Disengage the clamp.
Open the 2 fasteners.
Disengage the 4 claws and remove the 2 front seat headrest supports.
19.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the separate type front seatback cover with pad.
71074S
20.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Using a screwdriver, disengage the 17 claws and remove the separate type front seatback cover from the separate type front seatback pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510N
21.REMOVE FRONT SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
73920A
22.REMOVE FRONT SEAT AIRBAG ASSEMBLY
72760D
23.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY (w/ Lumbar Support)
71054S
24.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY (w/o Lumbar Support)
Disengage the 2 claws to remove the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this direction |
Remove the front seatback spring sub-assembly from the front seatback frame sub-assembly as shown in the illustration.
71587
25.REMOVE FRONT SEATBACK EDGE PROTECTOR (w/ Lumbar Support)
Remove the 2 front seatback edge protectors from the lumbar support adjuster assembly.
71587
26.REMOVE FRONT SEATBACK EDGE PROTECTOR (w/o Lumbar Support)
Remove the 2 front seatback edge protectors from the front seatback spring sub-assembly.
71759B
27.REMOVE FRONT SEATBACK HOOK
Remove the 2 front seatback hooks from the front seatback frame sub-assembly.
8219B
28.REMOVE FRONT SEAT NO. 2 WIRE (w/ Lumbar Support)
Disengage the clamp to remove the front seat No. 2 wire.
29.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
w/ Seat Heater System:
Disengage the claw and 4 clamps to separate the front seat cushion heater assembly wire harness.
Disengage the 4 clamps first.
Disengage the 2 hooks.
Disengage the 10 hooks and remove the separate type front seat cushion cover with pad.
71072S
30.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Using a screwdriver, disengage the 13 claws and remove the separate type front seat cushion cover from the separate type front seat cushion pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510L
31.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
739F0
32.REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Front Passenger Side)
w/ Occupant Classification System:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SRS SEAT CUSHION AIRBAG ASSEMBLY>REMOVAL
71874A
33.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the claw and guide to remove the front seat lower cushion shield LH.
71874A
34.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the claw and guide to remove the front seat lower cushion shield RH.
71875G
35.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER LH (for Driver Side)
w/ Lumbar Support:
Disengage the claw.
Disengage the 4 claws to remove the LH seat reclining adjuster inside cover LH.
71876G
36.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER RH (for Driver Side)
Disengage the 4 claws to remove the LH seat reclining adjuster inside cover RH.
71875F
37.REMOVE RH SEAT RECLINING ADJUSTER INSIDE COVER LH (for Front Passenger Side)
w/ Occupant Classification System:
Disengage the clamp.
Disengage the 4 claws to remove the RH seat reclining adjuster inside cover LH.
71876F
38.REMOVE RH SEAT RECLINING ADJUSTER INSIDE COVER RH (for Front Passenger Side)
Disengage the 4 claws to remove the RH seat reclining adjuster inside cover RH.
82192
39.REMOVE FRONT SEAT WIRE LH (for Driver Side)
w/ Lumbar Support:
Disconnect each connector and disengage each clamp to remove the front seat wire LH.
82192B
40.REMOVE FRONT SEAT NO. 2 WIRE LH (for Driver Side)
w/ Airbag Cut Off Switch:
Disengage the clamp.
Disengage the claw to remove the front seat No. 2 wire LH.
82191
41.REMOVE FRONT SEAT WIRE RH (for Front Passenger Side)
w/ Occupant Classification System:
Disconnect each connector and disengage each clamp to remove the front seat wire RH.
7181B
42.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER
Remove the 2 screws.
Disengage the claw to remove the front seat cushion wire harness holder.
71052A
43.REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY
Disengage the 6 hooks to remove the front seat cushion spring sub-assembly from the front seat adjuster assembly.
72211C
44.REMOVE SEAT TRACK ADJUSTING HANDLE
Disengage the 2 claws to remove the seat track adjusting handle from the front seat adjuster assembly.