Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY
RM3210E _58 Vehicle Interior _047538 SEAT BELT _0234840 FRONT SEAT INNER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

CAUTION:
·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Hide 73240 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.

Disconnect each connector.


b.

Disengage each clamp.


c.

for Manual Seat:

i.
B442322

Disengage the 2 clamps.


ii.

Remove the nut and front seat inner belt assembly.



d.
B442323

for Power Seat:

i.

Disengage the 2 clamps.


ii.

Remove the nut and front seat inner belt assembly.



e.
B435002C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.


Hide 73230 4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.

Disconnect each connector.


b.

Disengage each clamp.


c.
B434998

Disengage the clamp.


d.

Remove the nut and front seat inner belt assembly.


e.
B435001C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.