Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › CANISTER(w/ Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047497 2ZR-FXE EMISSION CONTROL _0236608 CANISTER(w/ Canister Pump Module) A

2ZR-FXE EMISSION CONTROL  CANISTER(w/ Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 77740R 1.INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY

HINT:

Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.


a.
A377744

Engage the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly.

NOTICE:
·

Do not allow foreign matter such as grease, oil or water to adhere to the O-ring.

·

Ensure that the claws are engaged properly.




Hide 77740 2.INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.
A377737

Install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.


b.

Install the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Connect the purge line hose to the canister (charcoal canister assembly) and slide the clip to secure it.


d.
A377733C01
1.948,2.76 2.26,2.76 false 2.292,2.656 2.76,3.042 0.469,0.385 10 false *a
*a Retainer
V100135

Push in


Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.




e.

Connect the leak detection pump sub-assembly connector.


f.

Push in the fuel tank vent hose sub-assembly to the pipe (leak detection pump sub-assembly) until the fuel tank vent hose sub-assembly makes a "click" sound.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (leak detection pump sub-assembly) before performing this work.

·

After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.




Hide 48832A 3.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.

Install the rear No. 1 stabilizer bar bracket to the vehicle body with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)


Hide 57628C 4.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 58390 5.INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY

Hide 17430 6.INSTALL TAIL EXHAUST PIPE ASSEMBLY