Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › FUEL VAPOR CONTAINMENT VALVE(w/ Canister Pump Module)
RM3210E _51 Engine / Hybrid System _047497 2ZR-FXE EMISSION CONTROL _0236610 FUEL VAPOR CONTAINMENT VALVE(w/ Canister Pump Module) A

2ZR-FXE EMISSION CONTROL  FUEL VAPOR CONTAINMENT VALVE(w/ Canister Pump Module)  REMOVAL  


PROCEDURE

Hide 58390 1.REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY

Hide 77710B 2.REMOVE FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY)

a.
A377748

Disconnect the fuel vapor containment valve (fuel tank solenoid main valve assembly) connector.


b.

Disconnect the fuel tank vent hose sub-assembly and fuel tank vent hose from the fuel vapor containment valve (fuel tank solenoid main valve assembly).

A377749C01
6.292,1.396 6.469,0.885 6.469,0.885 6.656,0.885 false 4.885,0.823 5.135,0.823 5.135,0.823 5.365,1.333 false 6.052,2.115 6.25,2.615 6.25,2.615 6.438,2.615 false 5.146,2.552 5.396,2.552 5.396,2.552 5.604,1.948 true 1.823,0.167 2.042,0.167 2.042,0.167 2.375,0.365 true 2.979,1.031 3.25,1.438 3.25,1.438 3.458,1.438 true 2.49,2.375 2.833,2.375 false 1.833,2.271 1.958,2.271 1.958,2.271 2.094,2.031 true 1.615,0.083 1.823,0.271 0.208,0.188 10 true *1 6.74,0.802 7.052,1.156 0.313,0.354 10 false *3 2.875,2.281 3.198,2.5 0.323,0.219 10 false *a 1.646,2.177 1.958,2.406 0.313,0.229 10 false *b 4.708,0.74 5.042,1.031 0.333,0.292 10 false *c 4.948,2.469 5.26,2.75 0.313,0.281 10 false *d 3.531,1.354 3.833,1.646 0.302,0.292 10 true *2 6.5,2.51 6.823,2.729 0.323,0.219 10 false *a
*1 Fuel Tank Vent Hose Sub-assembly *2 Fuel Tank Vent Hose
*3 Pipe (Fuel Vapor Containment Valve (Fuel Tank Solenoid Main Valve Assembly)) - -
*a Retainer *b Tab
*c Tube Connector *d O-ring
V100135

Pinch
V100136

Pull
V100137

Pull off - -


NOTICE:
·

Remove any dirt or foreign matter on the tube connectors before performing this work.

·

Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connectors has an O-ring that seals the pipe.

·

Perform this work by hand. Do not use any tools.

·

Do not forcibly bend, twist or turn the fuel tank vent hose sub-assembly and fuel tank vent hose.

·

Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel tank vent hose sub-assembly and fuel tank vent hose.

·

If the tube connector and pipe are stuck, push and pull to release them.



HINT:

Do not remove the retainer.


i.

Pinch the tabs of the retainer to disengage the lock claws and pull it down.


ii.

Pull off the fuel tank vent hose sub-assembly and fuel tank vent hose.



c.
A377750

Remove the 2 nuts and fuel vapor containment valve (fuel tank solenoid main valve assembly) from the vehicle body.