The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17430
3.REMOVE TAIL EXHAUST PIPE ASSEMBLY
58390
4.REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY
Remove the 3 bolts.
Disengage the clip to remove the No. 1 floor under cover assembly.
57628C
5.REMOVE REAR FLOOR SIDE MEMBER COVER LH
Remove the 3 bolts and clip (A).
Disengage the clip (B) to remove the rear floor side member cover LH.
77641A
6.REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.
77404
7.DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY
Disconnect the fuel tank vent hose sub-assembly from the fuel tank solenoid main valve assembly.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77213E
8.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
46430
9.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts and separate the No. 3 parking brake cable assembly.
77209F
10.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL SYSTEM>PRECAUTION
77100
11.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
12.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the 3 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77404
13.REMOVE FUEL TANK VENT HOSE SUB-ASSEMBLY
Disengage the 2 clamps to remove the fuel tank vent hose sub-assembly from the fuel tank assembly.
77606
14.REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Remove the 3 clips and No. 1 fuel tank protector sub-assembly from the fuel tank assembly.