This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the entry and start system related items that are customizable via the navigation system vehicle customization screen.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing malfunction | ·
CAN communication system ·
Entry and start system ·
Certification ECU (smart key ECU assembly) ·
Radio and display receiver assembly |
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
Use the GTS to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
CAN communication DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the entry and start system is malfunctioning.
for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING
for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING
Customization may not be possible depending on the malfunction in the entry and start system.
No malfunctions are present in the entry and start system.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING
for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING
Make a note of the customizable items for the certification ECU related system.
The items shown as customizable via the navigation system vehicle customization screen can also be changed using the GTS. In the following step, the GTS will be used.
To match-up the items on the navigation system vehicle customization screen with the items on the GTS, check the customize parameters list for the entry and start system related items that can be customized via the navigation system vehicle customization screen.
for Entry Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>CUSTOMIZE PARAMETERS
for Start Function: Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Start Function)>CUSTOMIZE PARAMETERS
Using the GTS, confirm that it is possible to change the settings of the customize parameters that are available for customization via the navigation system vehicle customization screen.
The items available for customization via the navigation system vehicle customization screen can be customized successfully using the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG