This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not completed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1516 | Torque Sensor Zero Point Adjustment Incomplete | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | - | EPS warning light: Comes on | Power switch on (IG) again | There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration. |
If the electric power steering column sub-assembly has been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs. (Step 1)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Calibrate the torque sensor zero point. (Step 2)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
| Tester Display |
|---|
| Torque Sensor Adjustment |
Check for DTCs. (Step 3)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
If DTCs are output, perform steps (1) to (3) two more times.
| Result | Proceed to |
|---|---|
| DTCs are still output after performing steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
A
B
Replace the power steering ECU assembly.
for LHD: Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING ECU(for LHD)>REMOVAL
for RHD: Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING ECU(for RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs. (Step 1)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Calibrate the torque sensor zero point. (Step 2)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
| Tester Display |
|---|
| Torque Sensor Adjustment |
Check for DTCs. (Step 3)
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
If DTCs are output, perform steps (1) to (3) two more times.
| Result | Proceed to |
|---|---|
| DTCs are still output after performing steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
A
B