Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243309 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position.


b.
B435200C01
0,0 0,0 false
V113147

Install in this Direction


Temporarily install the front bumper assembly with the 2 clips as shown in the illustration.


c.

Install the 4 bolts.


d.

w/ TOYOTA Parking Assist-sensor System:

i.

Connect the connector.



e.

w/ Toyota Safety Sense:

i.

Connect the connector.



f.

w/ Fog Light:

i.

Pull back the side of the front bumper assembly and connect the connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.




g.

Engage the 4 claws.

HINT:

Use the same procedure for the RH side and LH side.



h.

Install the 12 screws.


i.
B435191C01
0,0 0,0 false
V113147

Install in this Direction


Install the front bumper assembly with the 2 pin hold clips as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



Hide 53289A 2.INSTALL RADIATOR SUPPORT OPENING COVER

a.
B435189C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Engage the 2 guides as shown in the illustration.


b.

Install the radiator support opening cover with the 5 clips.


Hide 3.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

Hide 4. INITIALIZATION GRILLE SHUTTER SYSTEM (w/ Exhaust Heat Recirculation System)

a.

Change the grille shutter control mode to normal mode and initialize the grille shutter system.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM>INITIALIZATION


Hide 5.PERFORM CALIBRATION (w/ TOYOTA Parking Assist-sensor System)