Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243321 BACK DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH  INSTALLATION  


PROCEDURE

Hide 76839B 1.INSTALL BACK DOOR GARNISH COVER (w/o Rear View Monitor System)

a.
B435955C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 3 claws as shown in the illustration to install the back door garnish cover.


Hide 76801 2.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.
B435953C01
0.573,1.188 1.167,1.073 true 1.406,0.906 1.979,0.771 true 2.323,1.635 2.667,1.104 true 0.375,1.115 0.688,1.271 0.313,0.156 10 false *1 2.094,0.667 2.406,0.823 0.313,0.156 10 false *a 2.708,1.01 3.021,1.167 0.313,0.156 10 false *a
*1 Lower No. 2 Back Window Moulding
*a Tape


Pull back the lower No. 2 back window moulding and secure it with tape as shown in the illustration.

NOTICE:

Be careful not to damage the lower No. 2 back window moulding.


HINT:
·

Use wide tape to ensure strong enough adhesion.

·

Use non-residue tape.

·

If necessary, clean the lower No. 2 back window moulding before securing it with tape.




b.
B435952C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 13 clips as shown in the illustration.

HINT:

Check that the lower No. 2 back window moulding is not caught under the back door outside garnish sub-assembly.



c.

Install the back door outside garnish sub-assembly with the 6 bolts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


d.

Remove the tape.

NOTICE:

Be careful not to damage the lower No. 2 back window moulding.



Hide 67751 3.INSTALL BACK DOOR TRIM BOARD

Hide 67750 4.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 74811B 5.INSTALL DOOR PULL HANDLE

Hide 67938A 6.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 7.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 64790B 8.INSTALL BACK DOOR UPPER TRIM PANEL ASSEMBLY